Silverson Laboratory Mixer
Quick Set-up Guide for Model L5M-A
This video explains how to set up and use your Silverson Laboratory mixer. It is intended as a basic guide to get you started with the machine, but it is essential you read the Installation, Operation and Maintenance manual supplied with your machine before using it.
Jump to a Topic
Select a chapter below to go directly to that section of the video guide.
1. Setup and Machine Overview
- 0:29 – Unpacking and Initial Setup
- 1:12 – Preparing and Fitting the Mixing Assembly
- 1:44 – Why the Coupling Sleeve is Crucial
- 2:15 – How to Change Workheads
- 2:47 – Verifying Electrical Supply Before Use
- 2:58 – Using the Control Panel
2. Operation
- 3:42 – Final Check Before Operation
- 4:01 – Proper Mixer Start-Up and Positioning
- 4:30 – Adjusting Mixer Position for Viscosity Considerations
- 4:45 – Mixing Guidelines and Safety Measures
3. Troubleshooting and Maintenance
Maintenance and Cleaning
Proper maintenance and cleaning are essential to keep your Silverson Lab Mixer performing at its best and prolong its lifespan. Follow these key steps to ensure safe and effective care:
Regular Maintenance
- Inspect the Bearing Bushing: Check for signs of wear regularly, especially when mixing abrasive materials. Replace the bushing immediately if there is any movement of the shaft to prevent damage.
- Check the Workhead: Ensure the workhead is securely fitted and free from obstructions before use.
- Replace Worn Parts: Promptly replace any worn components to maintain optimal mixer performance.
Cleaning Guidelines
- Quick Rinse: In most cases, a short run in water, detergent, or other non-flammable solvent is sufficient to clean the wetted parts. The housing and wetted parts can also be cleaned with most household cleaning agents.
- Note: The mixer should never be sprayed with water nor immersed in water.
- Power Off for Deep Cleaning: If a more thorough cleaning is required, disconnect the mixer from the electrical supply before dismantling any parts. When flammable solvents are needed, ensure you are in a well-ventilated, safe area away from the mixer.
- Use Non-Abrasive Cleaning Methods: Avoid scouring with abrasive tools or using cleansers that could scratch, as they may damage the surfaces.
Best Practices for Longevity
- Clean the mixer after every use to prevent residue buildup.
- Refer to the installation, operation, and maintenance manual for detailed instructions and troubleshooting advice.
- For additional support or replacement parts, contact your local Silverson representative.
By following these steps, you’ll ensure your mixer stays in top condition and performs reliably for years to come.
Looking for spare parts?
Maintain top performance with genuine Silverson parts and accessories.